Girder Truss Shoe
Designed to provide a structural connection between a truss and a girder truss or beam
-Features a location tab allowing easy accurate alignment of the hanger
-Suitable for face fix or wrap-over fixing
-Manufactured from 1.2mm thick galvanised steel to BS EN 10346 DX51D + G275
-Fix using BPC 30x3.75mm sherardised nails in all pre-punched holes
Mono Truss Shoe
Designed for use in a mono / short span / infill truss to girder connection in a low load situation
-Manufactured from 0.9mm thick galvanised steel
-Fix using BPC 30x3.75mm sheradised nails in all available holes
Hand Nail Plates
A cost effective method of jointing structural timbers (such as site built trusses) simply by nailing through the pre-punched holes. Plates must be fixed on both sides of the timber
-Manufactured from galvanised steel to BS EN 10346:2009 + G275
-The pressed dimple design adds strength and rigidity to the component whilst also assisting in the location of nails
-Fix using BPC Sheradised Square Twisted Nails 30x3.75mm
Splice Plates
An economical on-site method of butt jointing timbers of similar section
-Suitable for use when replacing rotten floor joist ends, replacement of fire damaged timbers and repairing localised structural timber damage
-Must be fixed in sets of 4 per joint, minimum timber thickness 50mm
-Fix using BPC sherardised square twist nails in all available holes
Splice Plate Kits
An economical on-site method of butt jointing timbers of similar section
-Suitable for use when replacing rotten floor joist ends, replacement of fire damaged timbers and repairing localised structural timber damage
-Must be fixed in sets of 4 per joint, minimum timber thickness 50mm
-Fix using BPC sherardized square twist nails in all available holes
-Box includes required nails
Truss Clips
Truss Clips provide an inexpensive and effective method of fixing trussed rafters to wallplates
-Manufactured from 1mm thick galvanised steel
-Can also be used for general applications as a multi-purpose connector to provide restraint whenever two timber members cross
-Fix using BPC 30x3.75mm sherardised square twist nails in all pre-punched holes