Straddle Type Masonry Hanger
The straddle type joist hanger is used when timber joist positions are directly opposite each other on either side of a wall or beam
-As standard the straddle hanger is manufactured to suit 100mm blockwork
-Hangers 150mm deep and over are manufactured 10mm less to allow for notching and regularisation of timber joists
-All hangers feature 75mm bearing surface and pre-punched side gussets to allow nail fixing into timber joists with 30 x 3.75mm sherardised square twist nails
-Wide top flange design offers increased loading capacity on masonry with a minimum crushing strength of 2.8N/mm2 and above
-As standard all hangers are manufactured from 2.0mm thick pre-galvanised steel to BS EN 10346 : 2009, DX51D + G600 compliant with BS6178: Part 1:1990 and to the requirements of BS5268
Return Type Masonry Hanger
We recommend the use of return flange hangers wherever possible for all timber to brick applications
-The Return type hanger is designed for similar application to the Standard but with the advantage of a return flange (25mm as standard ) which greatly increases lateral support by giving the top flange additional resistance to pull out
-Hangers 150mm deep and over are manufactured 10mm less to allow for notching and regularisation of timber joists
-All hangers feature 75mm bearing surface and pre-punched side gussets to allow nail fixing into timber joists with 30 x 3.75mm sherardised square twist nails
-Wide top flange design offers increased loading capacity on masonry with a minimum crushing strength of 2.8N/mm2 and above
-As standard all hangers are manufactured from 2.0mm thick pre-galvanised steel to BS EN 10346 : 2009, DX51D + G600 compliant with BS6178: Part 1:1990 and to the requirements of BS5268
Standard Single Piece Masonry Hanger
The standard Single Piece Masonry Hanger is designed for building into brickwork or blockwork
-Hangers 150mm deep and over are manufactured 10mm less to allow for notching and regularisation of timber joists
-All hangers feature 75mm bearing surface and pre-punched side gussets to allow nail fixing into timber joists with 30 x 3.75mm sherardised square twist nails
-Wide top flange design offers increased loading capacity on masonry with a minimum crushing strength of 2.8N/mm2 and above
-As standard all hangers are manufactured from 2.0mm thick pre-galvanised steel to BS EN 10346 : 2009, DX51D + G600 compliant with BS6178: Part 1:1990 and to the requirements of BS5268